Controller Settings

  

Arduino UNO R3 Micro controller
Sketch Rev
Debugging messages	Yes No
Manual Mode default timeout		sec	- 14400=4hr 86400=24hr
Min Relay signal time		msec	- Minimum time required to switch the latching relays
IP timeout		msec	- timeout for ethernet requestes
Update time		msec	- period for updating readigns from solar inverter
Pulse time		msec	- time for pulse to trigger power relays
Auto in-delay		msec	- Delay before pump cuts in after cutinPower is reached
Auto out-delay		msec	- Delay before pump cuts out after cutoutPower is lost
Automatic pool pump switching
Use Auto pool pump switching	Yes No		The systems defaults to automatic switching and setting to manual returns it to auto after a set or default time. This behaviour can be turned off, for example to prevent the pump from running for extended periods.
Running with solar power
Minimum runtime per day	Jan:  Feb:  Mar:  Apr:  May:  Jun:  Jul:  Aug:  Sep:  Oct:  Nov:  Dec:	min	- If the minimum time for each day, by the month of the year, is not reached during the day, the balance is made up at night during off-peak billing
Cut in Power		Watt	- power above which the pump cuts in
Cut out power		Watt	- power below which the pump drops out again
Running with daylight for solar water heater
Minimum daylight running time		min	- Minimum tiome to run the pool pump during the hours the solar heater operates
max runtime per day		min	- the maximum time the pump will run in auto mode
Solar heater start hour		Hour	0 to 24 - time of day when the solar heater is configured to start running
Solar heater end hour		Hour	- of the day after which the solar heater does not operate
Running off-peak, if required, to make up minimum pumping time
Off-peak start hour		Hour	- when off-peak billing commences
Off-peak end hour		Hour	- when off-peak billing commences
Today Runtime start hours		Hour	- at which the todayPower and todayRuntime are set to zero